Brian’s Super Clutchnet Race Clutch Swap

That's gotta be one of the roughest looking distributors I've ever seen.  Just look at the crud coming off the coil.  Holy sh*t.

When you get a chance, bring that poor thing to me for some luvin....:)

Or....I've even got a jacked up rebuilt on the shelf as we speak.  Could bring it to Dave's tonight.  I want $250 for it.  You can pay me after the race season is over.

DG

Pics and write up from the day.

Well I took the car for several runs around the town, then we took it for a couple drives, then he took it for a drive, then I drove it to his house 20kms away, while he followed in his other car, then he drove me back in the Fiero to my place and he is on his way back to his place.  He is going to take it for a long cruise tomorrow before hitting the track on Saturday.  To be frank this clutch has so much bite, that even if it did not get seated perfectly, it would still be fine.  Without even dropping it hard, it has the ability to spin the R888's that are on the car now. 

Ok well I should post the final wrap up info and pics from the day, so here goes.  Sorry I did not get pics of the new MSD wires, it was getting dark by the time we got the final tune on the car and frankly I could have used another day of turning to get it perfect.

More on that as time goes on.

Ok first pics, this was a back woods attempt at repairing the boots on the old MSD wires, wrapped in shrink tube.  It didn't work as there must have been internal issues as well.  The boots were stretched to the point that a few of them had small tears.  The shrink tube worked wit the heat, just not the internal stuff.  So a new MSD 8.5mm Superconductor kit was bought, then spent the better part of an hour and a half building the new wires.

 

Now for the plugs.  Note all 3 have different burn patterns, its because all 3 had slightly different gaps.  Obviously the widest gap was running the leanest and is bleach white, the other 2 are normal to slightly rich.

Last pics were my answer to the bad dist shaft.  Took a spare old one out of my dist shafts bin, ground the body smooth, then polished it wit the wire wheel, and wiped it down with degrease.  Turned out pretty good.  I sat down with Brian and showed him how to rebuild the dist shafts so he was pleased that he will be able to do that in the future without having to come and pay someone to do it for him.  It now has a new Delco Module, and new Pickup Coil.

All is well wit the car and I hope he will be happy with it for a good time to come.

Really?  Aren't they almost twice the price?  And you still don't get a heat sink.....<wink>

I'm just glad to see you race ready.  Give'im hell!

DG

Bassman wrote: honestly for $250 I would more than likely buy a new MSD distributor