Waylon, with some time on your hands I was hoping you could post up a schematic on how you wired up my LED's.

What parts were used, what values, and what wires had to be connected up to each part.

I would like this to be simple enough that I could go to the local Electronics supply store, tell them that I want XXX parts and XXX number of parts.

Then come home read your directions and start building these.  I want to install them in all my Fiero's.   I REALLY REALLY like what you did.  I have gotten several comments from people about it.

So Please post up the info, unless you want to keep it a trade secrete.

ill get the part numbers together . and the proper resistors

 i would rathre get the parts for the  set up and people can get them from me  as i get things cheaper because of cost at the electronics store .  parts needed are l.e.d. (whatever size )  resistors (one per l.e.d.) and a single transistor . Along with the required glue filled heat shrink