|
Putting the door back on |
Post Reply 
|
| Author | |
Roadfury 
Senior Member 
Joined: 12 February 2007 Location: Canada Status: Offline Points: 211 |
 Post Options
 Quote Reply
 Topic: Putting the door back onPosted: 03 November 2009 at 8:41am |
|
I swapped doors out a while ago and there was only one bolt per hinge while the furthest spots were bolt less, im wanting to put those bolts back in but am haveing major problems putting the bottom one in... is there any tips to doing this???? thanks!
|
|
|
|
 |
|
|
Patrick
Newbie 
Joined: 19 April 2008 Location: Vancouver Status: Offline Points: 6 |
Post Options
Quote Reply
Posted: 03 November 2009 at 9:32am |
|
Are you having trouble putting the hinge bolts back into the door or into the frame?
|
|
|
|
|
Dr.Fiero
Senior Post God 
Joined: 12 February 2007 Location: Canada Status: Offline Points: 1726 |
Post Options
Quote Reply
Posted: 03 November 2009 at 9:47am |
|
Lower one on the frame/body side? IIRC the nut is loose inside the pillar. Been a while, but I seem to recall you need to pull back the carpet, and gently yank the 'tar paper' that covers the hole up.
|
|
|
|
|
Patrick
Newbie
Joined: 19 April 2008 Location: Vancouver Status: Offline Points: 6 |
Post Options
Quote Reply
Posted: 03 November 2009 at 9:53am |
|
Actually, it's a bolt that goes into the hinge from the inside of the pillar (opposite of the others), but it's difficult to tell if this is the problem that Mark is referring to. |
|
|
|
|
Dr.Fiero
Senior Post God
Joined: 12 February 2007 Location: Canada Status: Offline Points: 1726 |
Post Options
Quote Reply
Posted: 03 November 2009 at 10:05am |
|
Ah yes - that's it. Knew there was 'something' hidden in there... just been too long....
That aside - the whole hinge bolting on/off thing is the reason I simply pull the pins and lift off the door if I know it's going to go back on!!!! (the pins probably needed replacing anyhow) |
|
|
|
|
Patrick
Newbie
Joined: 19 April 2008 Location: Vancouver Status: Offline Points: 6 |
Post Options
Quote Reply
Posted: 03 November 2009 at 10:26am |
|
The only reason I knew was because something jammed inside the driver's door of my parts car a couple of months ago and the only way I could ultimately get the door open was to remove the damn hinges!
|
|
|
|
|
Roadfury
Senior Member
Joined: 12 February 2007 Location: Canada Status: Offline Points: 211 |
Post Options
Quote Reply
Posted: 03 November 2009 at 10:29pm |
|
So it is the bolts bolting hinge to body NOT hinge to door
And the bolts marked green are bolted from hinge to body (threads on body) and bolt marked red is bolted from the inside but from your thoughts it looks like im going to just tap out the pins and bolt them in cause i have to replace bushings anyway door wont line up 
|
|
|
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options
Dr.Fiero wrote: