|
88 GT rear wheel bearing |
Post Reply 
|
| Author | |
Medic 
Senior Member 
Joined: 31 October 2010 Location: Canada Status: Offline Points: 121 |
 Post Options
 Quote Reply
 Topic: 88 GT rear wheel bearingPosted: 04 October 2012 at 4:01pm |
|
My rear wheel bearing is shot and I need a socket to take off the big nut. Anybody know what size that nut is? I have to buy a socket and need to know the size before I spend hours driving back and forth to get the right size deep socket..
|
|
|
88 GT Northstar 6 Spd
|
|
 |
|
|
Dr.Fiero
Senior Post God 
Joined: 12 February 2007 Location: Canada Status: Offline Points: 1726 |
Post Options
Quote Reply
Posted: 04 October 2012 at 6:00pm |
|
30mm IIRC
|
|
|
|
|
Capt Fiero
Admin Group
Founding Member Joined: 12 February 2007 Location: Canada Status: Offline Points: 4039 |
Post Options
Quote Reply
Posted: 04 October 2012 at 8:13pm |
|
If you can make it to my place by 2pm tomorrow, you can borrow mine. I am leaving for Oregon tomorrow.
FYI, it must be a DEEP socket. |
|
|
Capt Fiero
88 Fiero GT 5spd V6 Eight Fifty Seven GT V8 5spd. |
|
|
|
|
Medic
Senior Member
Joined: 31 October 2010 Location: Canada Status: Offline Points: 121 |
Post Options
Quote Reply
Posted: 08 October 2012 at 4:07pm |
|
Done, it was the easiest wheel bearings I have done. Now if I can only
figure out that slow speed stall issue......... |
|
|
88 GT Northstar 6 Spd
|
|
|
|
|
Capt Fiero
Admin Group
Founding Member Joined: 12 February 2007 Location: Canada Status: Offline Points: 4039 |
Post Options
Quote Reply
Posted: 08 October 2012 at 5:17pm |
|
Congrats on the Repair, as for the low speed stall issue I can't help you, Northstar programing is WAY above my head, I would check with a few guys on Pennocks, there are some Wizards with the Northstar stuff there.
|
|
|
Capt Fiero
88 Fiero GT 5spd V6 Eight Fifty Seven GT V8 5spd. |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options